Aventics PROFINET-IO Mode D'emploi page 95

AVENTICS | PROFINET-IO | R412015162–BDL–001–AE
Before starting configuration, the following steps must have
been carried out and completed on the bus coupler:
W
You have assembled the bus coupler and valve terminal
(see "Assembly" on page 76).
W
You have connected the bus coupler (see "Connecting the
modules electrically" on page 77).
W
You have carried out the presettings (see "Making
presettings" on page 87).
The configuration may also be carried out using other
configuration software, but the described parameters and
settings must be adhered to.
No changes may be made to the configuration and
hardware during operation!
O
Configure the bus coupler system in accordance with your
system requirements, the specifications in the device
master data files (GSDML-V2.2-BREX-CMS-B-
yyyy.mm.dd.xml), the manufacturer's specifications, and all
valid technical standards, directives, and safety regulations.
Take the operator's documentation on configuring the
IO controller into account.
In order to work on the right device, you must first search
according to slave (Durchsuchen).
Commissioning and Operation
95