Publicité
INSPECTION REGISTER
AIM AND POURPOSE OF THE INSPECTION REGISTER
The CONTROL REgIsTER forms an integral par of Effer crane and it i mandatory as per national standard and laws. The inspec-
tion register has the purpose to take notes of the history of the crane as regards data, operations of installation, maintenance,
repairs, proofs, processing, tests, safety status and preservation checks.
The inspection register contains:
- Instructions for storage / fill in
- Definition of qualification and responsibilities
- Property transfer register
- Register / Putting into service Validity
- Crane/ installation technical data
- Overload test record
- Register of maintenance and repairs / replacements
- Register of the peridical checks
- Repair record
- Replacement record
- Crane transformations register/ accessory application
- Register of the conditions of use of the crane/ accessory
- Record of crane/accessories service life monitoring
- Record of special maintenance/inspections (non-routine, overhaul, inspections carried out by third parties, etc.)
- Cable maintenance record
- Annexes/various documents record
- EFFER support centres
The inspection register so constituted is an important document to which EFFER can refer in case of warranty
(•)
request, dispute and accident.
**
(
) (**) Machinery directive 2006/2/CE (European Union and associated countries within the
This inspection register must comply with other laws / national regulations which may vary depending on country of use of the crane. It's up to the owner /
employer / installer to observe these issues according to national legislation.
Country of use: Italy (National legislation: decree No. 81/08 transposition of Communitarian directives).
The employer must take steps to ensure that:
Article. 71 paragraph
a) work equipment are:
1-Installed and used in accordance with the manual instruction;
2 - properly maintained and overhauled so as to ensure long-life to the safety requirements according to the Article 70, and they are supplied, if
necessary, by appropriate instructions reported in the use and maintenance manual.
b) correct recording and updating of the inspection register for work equipment for which it was intended (for lifting equipment the inspection
register is provided in Annex 1 of Machinery directive 2006/2/EC)
Article 71 paragraph 7
If the equipment (lifting equipment) require special knowledge for their use or special responsibilities in relation to their specific risks, the
employer must take steps to ensure that:
a) the use of work equipment is restricted to those persons which have received adequate knowledge, specific information, and adequate training.
b) in case of repairs, transformations, or maintenance, the involved workers must be qualified and specifically trained to undertake such tasks.
Article 71 paragraph 8
Notwithstanding the provisions of paragraph , the employer, ......., so provides;
a) work equipment whose safety depends on the installation conditions, are subject to an initial check (after installation and prior to commissioning) and
inspection after any assembly at a new site, or at any new location of the unit, for the purpose of ensuring correct installation and proper operation.
b) equipment exposed to conditions which may cause deterioration or liable to cause any dangerous event are subject to:
1) Periodic checks according to the intervals determined by the manufacturer's instructions, or by the standards of good practice, and if failing
this, derived from good practice.
2) extraordinary service interventions so as to ensure maintenance safety good conditions, every time any event occurs under any exceptional
circumstances that may have adverse consequences for the safety of work equipment such repairs, changes, accidents,
natural phenomena or prolonged periods of inactivity.
c) the control actions referred to in subparagraphs a) and b) are performed to ensure a good status of preservation and efficiency of the work
equipment with the aim of safety, and are performed by a competent person.
Article 71 paragraph 9
The results of the inspections referred to paragraph B must be reported in writing, and at least those regarding the past recent years, must be
saved and kept available to supervisors.
Y
European Economic Area (EEA)
MO00062_1
Publicité
Chapitres
