Publicité
GENERAL SPECIFICATIONS
The EFFER hydraulic crane can be defined 'Loader Crane' (cranes for loading) - according to EN12999, which means machineries
usually combined with a vehicle (semi-trailer included) and generally planned for loading and unloading the vehicle; they may be
installed even in different conditions (pedestal installation or on vessel).
The installer's task is to establish the proper coupling crane-vehicle (or anything else); he is responsible for the correct project/
execution of some parts/circuits necessary for the crane installation as well as for their duly mounting.
We report here below the main aspects of the proper installation along with some indicative suggestions which are not binding.
Please comply in any case with the regulations in force.
The calculations given below and the mechanical design and diagrams must be performed by a competent technician.
Truck/suitable vehicle, position of the crane:
Choice of the suitable supplementary stabilizers:
(fig.1a)
Choice of the sub-frame (fig.1b):
Choice of the counter-chassis connections:
Choice of the power take-off/pump:
Choice of the hydraulic and electric circuits:
for connecting the different crane components
Access and control seats:
Possible calculation of the foundations for fix
installation:
Global security check:
(check carefully all possible dangers)
Practical tests for static and dynamic stability :
Installation final inspection and self-certifying:
(*): In the EU-SEE countries, the EC compliance to directive 2006/42/ EC of the whole machine/equipment, where the hydraulic
crane
is installed, has to be guaranteed by the installer/who starts the crane; this one has to release his own EC Declaration according to
enclosure II-A of the same directive.
The installer must carry out the installation following strictly the instructions given in the vehicle manual, given by the supplementary
stabilizers supplier and by all suppliers of components/accessories he will use and especially according to the regulations in force.
Upon request, EFFER supplies more detailed information. More detailed technical information is available at WWW.EFFER.COM
(area reserved for the installers).
TECHNICAL DATA
GENERAL INSTRUCTIONS FOR THE INSTALLATION OF
HYDRAULIC CRANES
calculation/check for the weights on the axles.
primary stability calculation according to EN12999-2010.
fitness calculation of the supplementary stabilizers according to EN12999-2010
(Supplier directions, if supplied by Effer, refer to the relevant table "DT00015-
Supplementary stabilizers" available in WWW.EFFER.COM (area reserved to
installers), where are indicated the minimum mounting distances from
the slewing centre of the crane of the supplementary stabilizers suitable for such
model).
counter-chassis calculation, see EN12999-2010.
calculations according to the regulations in force CUNA NC034-05 and Manual
of the vehicle supplier/supplementary stabilizers supplier, calculations according
to norms and formulas of correct design (ex: EN13001).
make Your calculation according to the maxi. oil displacement and the maxi.
pressure.
see regulations in force.
according to directive 2006/42/ EC, EN12999-2010.
calculation according to the regulations in force
according to directive 2006/42/ EC EN12999-2010
according to regulations DIN 15019, EN12999-2010, DIN 15018, directive
2006/42/ EC (table. E)
according to laws and regulations in force (*)
N.
DT00001GB
/3
Pag.
1
Rev.
1
Data
19/01/2011
Date
Prep.
UTD Ceccardi
Publicité
Chapitres
