Connector Assignments / Control Input And Output; Pin Assignment / Conductor Coloring Connector I (3-Terminal); Pin Assignment / Conductor Coloring Connector Ii (5-Terminal) - Ecolab EMP KKS E60 Manuel D'utilisation

14.6

Connector assignments / Control input and output

14.6.1

Pin assignment / conductor coloring Connector I (3-terminal)

Connector for low-level advance warning or empty report
WARNING!
In the event that the empty report is not used, contact 3/4 must always be
bridged! The protective cap provided for this
( Ä Chapter 7.2.1 ' Inputs and outputs' on page 36) creates the bridge between
he contacts and must be attached in this case.
NOTICE!
The empty and reserve report input can be inverted in the "Configuration / Low-
level contact" menu. (
on page 76).
14.6.2

Pin assignment / conductor coloring Connector II (5-terminal)

Connector for pulse / standard signal input and metering lock
NOTICE!
The metering lock input is only active if it has been previously set in
"Configuration / metering lock" menu
Ä Chapter 10.3.7 'Configuration / Metering lock' on page 75).
(
The batch function (
and metering monitoring (
monitoring' on page 82) must also be configured.
Conductor
Pos.
coloring
1 brown
3 blue
4 black
Ä Chapter 7.2.2 'Connection assignments of Slolt I (3-terminal)
Input for low-level advance warning and empty report '
on page 37).
Ä Chapter 10.3.8 'Configuration / Low-level contact'
Conductor
Pos. Assignment
coloring
1 brown Output 5 V, DC
2 white Pulse input
3 blue Input metering lock
4 black GND
5 grey Input standard signal 0/4 ... 20 mA
Ä Chapter 7.2.3 'Connector assignment of slot II (5-terminal) Input
for pulse signal, standard signal, metering lock, batch and metering
monitoring ' on page 39
Ä Chapter 10.3.15 'Configuration / Batch' on page 93)
Ä Chapter 10.3.13 'Configuration / Metering
127
Technical Specifications
Assignment
low-level advance warning
empty report
GND
417101442 Rev. 12-02.2019