Ecolab EMP KKS E60 Manuel D'utilisation page 232

Menu description
10.3.15.3 Batch / Input (only at E60 WITHOUT Dongle box)
The "Input" setting is used to determine which input (pulse or metering lock) at plug II (or
at plug VII if a dongle box is used) of the pump should be used to evaluate the start pulse
for the batch metering. The start pulse cable connection depends on the selected input.
Fig. 73: Batch / Input (only at E60 WITHOUT Dongle box)
Input pulse:
= plug II (or plug VII) Pin 2+4
Input metering lock:
= plug II (or plug VII) Pin 3+4
Ä Chapter 7.2.3.4 ' Installation Chargenfunktion' on page 42 & Ä Chapter
8.2.3.1 'Installing the batch pulse' on page 53.
Default setting = Metering lock
NOTICE!
In this case, the original function (e.g. pulse) can no longer be used. When
using a dongle box, a separate input is available.
417101442 Rev. 12-02.2019 96