Ecolab EMP KKS E60 Manuel D'utilisation page 250

Operating faults
Display Meaning
No communication
between dongle box
Operating faults: Alarm messages (display) Fault 12
No communication
between MicroFlow
Operating faults: Alarm messages (display) Fault 13
12.2.1
Disabling dongle box, OGM
The following procedure is applied to re-disable a peripheral unit
(dongle- box, OGM
then removed again, in the pump software:
Cancel the alarm signal which appears (see fig. 12.10, 12.11, 12.12) by pressing the Start/
Stop button.
Es erscheint folgende Anzeige im Display:
Dongle box
Disabling dongle box in the
pump software
Deactivation can be selected by pressing the sor t button, and the following is displayed
Dongle box
Disabling dongle box in the
pump software
The setting is applied by pressing the Start/Stop button.
417101442 Rev. 12-02.2019
Effect
pump stops
and pump
pump stops
box and pump
PLUS
, MicroFlow
PLUS , MicroFlow PLUS
OGM PLUS
Disabling OGM
software
OGM PLUS
Disabling OGM
software
Cause
Transmission of the data
has been disrupted
during operation
Transmission of the data
has been disrupted
during operation
PLUS
in the pump software
), which had previously been connected and was
MicroFlow
PLUS
in the pump Disabling MicroFlow
software
MicroFlow
PLUS
in the pump Disabling MicroFlow
software
114
Remedy
Check the connection
and replace the dongle
box if necessary
Check the connection
and replace the
MicroFlow if necessary
PLUS
PLUS
in the pump
PLUS
PLUS
in the pump