10.3.13 Configuration / Metering Monitoring - Ecolab EMP KKS E60 Manuel D'utilisation

Menu description
10.3.12.2 Displayanzeige in der Betriebsebene bei aktiviertem Dosierregler
HINWEIS

10.3.13 Configuration / Metering monitoring

If the metering monitoring function is enabled, the pump strokes are compared to the
incoming pulses using a connected external metering monitor (e.g. oval gear meter).
If a configurable tolerance threshold is breached, an alarm is triggered.
The metering monitoring system can be connected at plug II (or plug V if a dongle box is
used) at Pin 2+4 (input pulse) or at Pin 3+4 (input metering lock) (assortment of inputs
Ä Chapter 10.3.13.5 'Metering monitoring / Input (only at E60 WITHOUT Dongle box)'
on page 86), electrical connection
(OGM PLUS )' on page 50.
NOTICE!
If an oval gear meter is connected as a metering monitoring unit and should be
correspondingly evaluated, then the configuration/oval gear meter function
must be enabled in addition to the configuration/metering monitoring function
Ä Chapter 10.3.11 'Configuration / Oval gear meter (only E60
(
OGM
417101442 Rev. 12-02.2019
▼ = Downward metering divergence
The pump is currently delivering less than the preset stroke frequency
(here 100/min for example) requires.
Metering frequency is increased automatically until the actual value matches the
target value.
- = No metering divergence
The pump delivers exactly the preset flow
(here 100/min for example).
No correction is necessary.
▲ = Upward metering divergence
The pump is currently delivering more than the preset stroke frequency
(here 100/min for example) requires.
Metering frequency is reduced automatically until the actual value matches the
target value.
1 = Dongle Box mounted.
2 = Oval gear meter OGM
Ä Chapter 8.2.1.1 'Installing the oval gear meter
PLUS
)' on page 80).
PLUS mounted.
82
PLUS
&