Pole Mounting - Shockwave Medical 825D Manuel D'utilisation

EN
5.1 IV Pole Mounting
Step 1 – Locate and identify mounting hardware (see image below). Two identical sets of IV pole mounting
hardware are provided. One set is used to mount the Generator and one set is used to mount the battery
Charger Module.
IV Pole Mounting
Bracket
Side A
IV Pole Mounting
Bracket
Spring
IV Pole Mounting
Bracket
Side B
IV Pole Mounting
Bracket
Mounting Screws
Clamp Screws
IV Pole Mounting
Bracket
Insert
IV Pole Mounting Hardware
Step 2 –Determine the IV pole diameter at the desired mounting location. The mounting bracket will
accommodate IV pole diameters from 3/4 to 1 inch (19 mm to 25 mm).
NOTE: If the pole diameter 1 inch (25 mm) proceed to step 3.
If the IV pole is 3/4 inch (19 mm) in diameter, attach the IV Pole Mounting Bracket Insert to the side B
mounting bracket as shown below and proceed to step 3.
IV Pole Mounting
Bracket Insert
IV Pole Mounting Bracket
Side B
IV Mounting
Bracket Insert
Screws
LBL 60780 rev. B 17 | P a g e