AEG IAE84881FB Notice D'utilisation page 28

Problem
You cannot activate a function.
Assisted Cooking or Sous Vide
stops.
Hob²Hood does not work.
Hob²Hood operates, but only the
light is on.
Hob²Hood modes H1 - H6 operate,
but the light is off.
There is no sound when you touch
the panel sensor fields.
Wrong language is set.
A cooking zone deactivates.
A warning message saying the
cooking zone is going to switch off
comes on.
and a message come on.
O - X - A appears.
blinks.
and a number come on.
You can hear a constant beep
noise.
Cookware heats up longer than 5
min.
28 ENGLISH
Possible cause
Another function is running on the
same cooking zone, which prevents
the activation.
At the beginning of a cooking ses‐
sion the temperature of the liquid in‐
side the pot is higher than 40 °C.
The cookware in use is hot.
You covered the control panel.
You activated the H1 mode.
There might be a problem with the
light bulb.
The sounds are deactivated.
You changed the language by mis‐
take.
Automatic Switch Off deactivates
the cooking zone.
Lock operates.
Child Lock operates.
There is no cookware on the zone.
The cookware is unsuitable.
The diameter of the bottom of the
cookware is too small for the zone.
There is an error in the hob.
The electrical connection is incor‐
rect.
The bottom of the cookware is not
induction compatible.
Remedy
Stop the function before you acti‐
vate another.
Use only cold liquids.
Do not preheat the cookware.
Remove the object from the control
panel.
Change the mode to H2 - H6 or wait
until the automatic mode starts.
Contact an Authorised Service Cen‐
tre.
Activate the sounds. Refer to "Daily
use".
Reset all functions to the factory set‐
tings. Select Reset All Settings from
the Menu.
Disconnect the hob from the electri‐
cal supply. After 1 min, connect the
hob again. Set Language, Display
Brightness and Buzzer Volume.
Deactivate the hob and activate it
again.
Refer to "Daily use".
Refer to "Daily use".
Refer to "Daily use".
Put cookware on the zone.
Use suitable cookware. Refer to
"Hints and tips".
Use cookware with correct dimen‐
sions. Refer to "Technical data".
Deactivate the hob and activate it
again after 30 seconds. If
on again, disconnect the hob from
the electrical supply. After 30 sec‐
onds, connect the hob again. If the
problem continues, speak to an Au‐
thorised Service Centre.
Disconnect the hob from the electri‐
cal supply. Ask a qualified electri‐
cian to check the installation.
Use cookware with correct (flat,
magnetic) bottom. Refer to "Hints
and tips".
comes