Cleaning Eolife® And Its Accessories; Storing Eolife; Disposal; Technical Data - ARCHEON EOlife Instructions D'utilisation

Always check the battery level before placing the device in the emergency bag The battery level is shown in the top
right corner of the start-up screen
The battery icon fills as the charge increases and also changes colour:
Green
Run time ≥ 50%
Charge
Note
Under normal conditions of use and when the operating conditions specified in "X Technical data" are met,
the run time is around 5 hours from fully charged
Caution
When the symbol appears on the screen, the battery is probably defective, and you should use another battery to
avoid a power failure during resuscitation
b) Cleaning EOlife® and its accessories
o FlowSense®
The FlowSense® sensor is a single-use component of EOlife® (see "IX d) Disposal")
o Electronic unit and removable battery:
The electronic unit and the removable battery are reusable EOlife® components that must be cleaned after
each use to avoid cross-contamination
This mandatory and essential step is the user's responsibility
Caution
The EOlife® device must be switched off before being cleaned
Cleaning
After being used in a clinical situation, the electronic unit and the battery must be cleaned before re-use
If the electronic unit and the battery have been soiled, first wash them as
EOlife® and its battery are compatible with the "SURFANIOS Premium" and "Septalkan" cleaning solutions Make
sure you follow the manufacturer's instructions for these solutions when cleaning EOlife® and its battery
c) Storing EOlife®
After cleaning the electronic unit and the removable battery, check the battery level (see "IX 3 a) Charging the
battery")
Once charged, reconnect one of the batteries to the electronic unit and store EOlife® and its accessories in a place
that meets the storage conditions (see "X Technical data")
46
Orange Red
50% > Run time ≥ 20% 20% > Run time
d) Disposal
At the end of the EOlife® device's lifetime (lifetime of the various parts specified in "X Technical data"), it should be
disposed of as follows:
1. The EOlife® electronic unit, battery and charger contain electronic components and must be disposed of in an
appropriate recycling facility, in accordance with European Directive 2012/19/EU on waste electrical and electronic
equipment (WEEE)
They must not be disposed of with household waste Take them to an electrical and electronic equipment
recycling collection point They must be disposed of in accordance with local environmental regulations on waste
disposal For more detailed information on the handling, collection and recycling of this product, contact your
environmental officer or local council
2. Users must dispose of the FlowSense® sensor as biohazardous waste
X. Technical data

1. Technical data relating to the device

Specifications EOlife®
Product class according to
Regulation (EU) 2017/745
Dimensions 135 mm x 75 mm x 35 mm
Weight including battery 150g ± 5 g
o Temperature between 0°C and +40°C without monitoring relative humidity
o Relative humidity between 15% and 95% (non-condensing), not requiring a
Operating conditions
water vapour partial pressure greater the 50 hPa
o Atmospheric pressure range of 620 hPa to 1,060 hPa
o Temperature between -20°C and +50°C
Transient operating conditions
o Relative humidity between 15% and 90% (non-condensing), not requiring a
(maximum 20 min)
water vapour partial pressure greater the 50 hPa
o -40°C to +5°C without relative
humidity control
o +5°C to +35°C with a maximum
Storage conditions relative humidity of 90% (non-
condensing)
o 35°C to 70°C at a water vapour
pressure of up to 50 hPa
Lifetime 5 years
Power supply (nominal voltage) 3,7 V
Run time 5 hours
Classification according to EN
60601-1:
o Type of protection against The entire device except for the charger (electronic unit, battery and FlowSense®
electric shock sensor) has been designed to meet the requirements for type BF applied parts
o IP rating for protection
against electric shock
FlowSense®
Class I
Length: 69 3 mm
Flow tube diameter: 11 25 mm
FlowSense® inlet and outlet connections
comply with the EN 5356 standard
< 20 g
-40°C to +70°C with a maximum relative
humidity of 10% to 90% (non-condensing)
3 years
47