ABB DMI Série Mode D'emploi page 185

Mounting arrangements
IM 1001 IM 1002
Balancing
Class N Class R
Terminal box
Mounting of terminal box (facing D-end)
On the top Cable entrance:
On the right side
Cable entrance:
On the left side
Mounting on foundation
Foundation studs, set of 4 pcs.
Control and protection devices
Speed control devices
Tachometer
REO 444 R1
TDP 0,2-LT-4
Pulse generator
RS 522, (p=1024)
Others
Mounting details for Euro-flange device
Brakes
Holding/emergency brake
NFH 10 NFH 20
Braking torque adjusted
to Nm
Operating voltage
24 V DC
24-240 V DC
max 380 V AC, 40-60Hz
Heating element
Microswitch
Hand release
Test and documentation
Dimension drawings
Standard Specially drawn
Test
Report of the routine test
Report of a type test
Remarks:
If information is not given, the following will be assumed.
Accessories/options at no extra cost.
Accessories/options at extra cost.
Other requests
Cat. DMI 02-09/rev.0
IM 1011 IM 1031 IM 1051
Class S
From right
From top
Slide rails, set of 2 pcs.
REO 444 R2
RS 522 (p=2048)
Working brakes
NFH 40 NFH 80
V DC
V AC
V
IM 1061 IM 1071
Balancing with
(Notice: The terminal box cannot be placed in the same location as the heat
exchanger. Some restrictions even in combination with filter and fan.)
From left From D-end
From bottom From D-end
Temperature sensor in interpole and field windings
Thermistor
Warning
Thermostat
Warning
Resistance element for temperature indication (PT 100)
Bearing protection and monitoring
Grounding brush
SPM bearing sensor nipples in the end shields
Resistance element for temperature indication (PT 100)
Brush wear sensor
Sensors for detecting all brushes
Anti-condensation heater
Heater 220 V
Transparent inspection cover
Transparent cover
Painting
Special painting colour according to RAL
or Munsell
Shaft
Standard shaft design for IM xxx2
(max torque, see table on page 15)
Modified shaft design for IM xxx2
(max torque see table on page 15)
Bearings
Roller bearing on drive end (belt drive)
CARB bearing on drive end (belt drive)
Standard bearing, but locked on
D-end (e.g. vertical DMI)
Special bearing for vertically
mounted DMI
IM 2001 IM 2011
half key full key
From N-end
From N-end
Trip Warning and Trip
Trip Warning and Trip
V
IM 2031
7
185