Publicité
HOW TO CHANGE THE OVEN LIGHT BULB
Disconnect the appliance from the power supply or place the omnipolar switch in the OFF position.
Check that the oven is at room temperature, otherwise wait for it to cool.
The oven light bulb must have the following characteristics:
x Supply voltage 220-240V~ (50/60 Hz)
x power 25 W.
x Base type: E-14
x Maximum operating temperature 300°C
Instruction for changing the light bulb:
1. Unscrew the knurled nut of the left-side support grill,
see the previous page.
2. Extract the support grill.
3. Unscrew the 4 cross screws located on the corners
of the glass support (see drawing to the side).
4. Place the frame, with glass and seal to protect the lamp,
on a support surface.
HOW TO CHANGE THE COOKING CHAMBER SEAL
The seal located around the cooking chamber must be replaced if it has any cracks.
For safety reasons, the seal must be changed by an Authorized Service Centre technician.
Rubber seal
5. Unscrew the burnt-out bulb.
6. Insert and screw in the new light bulb.
7. Reassemble the frame assembly with glass and seal.
8. Screw in the 4 screws.
9. Reassemble the side grill.
10. Screw on the knurled nut of the side grill.
11. Reconnect power.
45
frame
glass
79
79
Publicité
