Télécharger Imprimer la page

Gorenje BOC 6322 AX Manuel D'installation Et D'emploi page 78

Publicité

WHAT TO DO IN CASE OF AN ANOMALY
PROBLEM
The oven does not work.
The light inside the cooking chamber does not turn
on.
The display shows Err and a number.
The system requires the time to be set.
The draining of the water from the boiler occurs a
long time after the end of a cooking process.
Steam comes out of the oven during operation.
The system displays a food probe temperature
during operation without the food probe
connected.
WHAT TO DO IN CASE OF POWER CUT-OUT
In the case of a black-out, when the electricity is restored it may be necessary to reset the current time.
The stored settings or recipes are not lost.
If the black-out occurs during a cooking process, the process cannot continue.
If a descaling or boiler cleaning process was in progress before the black-out, the process is aborted. When the
electricity is restored, it will be necessary to drain the solution of water and citric acid monohydrate contained in the
boiler. Follow the instructions shown on the display of the appliance.
76
SOLUTION
Check whether the omnipolar switch or any residual-
current circuit breaker (cut-out) of the electrical system is
off. In case of problems with the electrical system, consult
a qualified electrician. If the oven still does not work after
resetting the omnipolar switch and/or residual-current
circuit breaker, contact an Authorized Service Centre.
See the instructions on how to change the oven light bulb.
This combination indicates a failure.
See the error codes table.
Probable electricity failure (Black-out). Set the current
time.
For safety reasons the water from the boiler is pumped
away only when the temperature has dropped below
90°C.
The time necessary for the water to cool determines the
pause before the draining starts.
(this may last up to 20 min.)
During this time, another cooking process can be started.
Check whether the door is closed correctly.
Check whether the seal is damaged with cracks, etc. In
the second case, contact an Authorized Service Centre.
Check the seal of the food probe connector cap inside the
cooking chamber. If the cap is unstable, it must be
replaced.
Contact an Authorized Service Centre.
42

Publicité

loading