Codes D'interruption Sdo - Siemens SINAMICS S120 Manuel De Mise En Service

Introduction
1.9 Services SDO

Codes d'interruption SDO

Tableau 1- 7 Codes d'interruption SDO
Code d'interruption
0503 0000 hex
0504 0000 hex
0504 0001 hex
0504 0002 hex
0504 0003 hex
0504 0004 hex
0504 0005 hex
0601 0000 hex
0601 0001 hex
0601 0002 hex
0602 0000 hex
0604 0041 hex
0604 0042 hex
0604 0043 hex
0604 0047 hex
0606 0000 hex
0607 0010 hex
0607 0012 hex
0607 0013 hex
0609 0011 hex
0609 0030 hex
0609 0031 hex
0609 0032 hex
0609 0036 hex
060A 0023 hex
0800 0000 hex
0800 0020 hex
0800 0021 hex
0800 0022 hex
0800 0023 hex
30
Description
Toggle bit not alternated.
SDO protocol timed out.
Client/server command specifier not valid or unknown.
Invalid block size (block mode only).
Invalid sequence number (block mode only).
CRC error (block mode only).
Out of memory.
Unsupported access to an object.
Attempt to read a write only object.
Attempt to write a read only object.
Object does not exist in the object dictionary.
Object cannot be mapped to the PDO.
The number and length of the objects to be mapped would exceed PDO
length.
General parameter incompatibility reason.
General internal incompatibility in the device.
Access failed due to an hardware error.
Data type does not match, length of service parameter does not match.
Data type does not match, length of service parameter too high.
Data type does not match, length of service parameter too low.
Sub-index does not exist.
Value range of parameter exceeded (only for write access).
Value of parameter written too high.
Value of parameter written too low.
Maximum value is less than minimum value.
Resource not available: SDO connection.
General error.
Data cannot be transferred or stored to the application.
Data cannot be transferred or stored to the application because of local
control.
Data cannot be transferred or stored to the application because of the current
device state.
Object dictionary dynamic generation failed or no object dictionary is present
(e. g. object dictionary is generated from file and generation fails because of a
file error).
Manuel de mise en service, IH2, 01/2013, 6SL3097-4AA00-0DP0
Interface CANopen