Remove the bolt (8), pad retainer (7) and pad springs (6).
For brake with PWI (Pad Wear Indicator), see the brake manual.
Remove pads (5).
Fitting brake pads
Make sure that the adjustment shaft (55) is fully retracted using
an 8 mm ring spanner. Ensure that the protection springs (30)
(protection springs (30) are optional) are positioned correctly so
that they are not jammed/damaged or interfere with the backward
travel of the thrust plates (28). Check that the contact surfaces of
the pads (5) in the disc brake are free from dirt.
Fit the brake pads (5).
For brake with PWI (Pad Wear Indicator), see the brake manual.
Fit the pad springs (6), pad retainer (7) and secure
with a bolt (8). Tightening torque 45±5Nm.
RI 003-04/11
Section 1
Preliminary
-
31 -