Table des Matières
Publicité
Checking slide function
Check the sliding motion of the calliper (2) on slide
pins (13). The calliper (2) must be free to slide on
the slide pins (13), max. slide resistance 100 N. If
slide resistance is higher, check that the movement is
not hindered by external dirt, foreign objects etc. If
remedial measures are required, see the brake manual.
IMPORTANT! The disc brake must be mounted
on the axle and the brake bolts fully tightened for
this check.
Checking play in slide function
Measure the play in the outer slide pins (13) by
attaching a magnetic stand complete with a dial
gauge on carrier (3), with the tip of the dial gauge
on point (A) as illustrated. Lift and lower the calliper (2)
outside the brake disc and read off the dial gauge.
Repeat the procedure inside the brake disc for the
inner slide pins (13) and measure at point (B). The
method for obtaining a play, measurement must be
adapted to the 'clock position' of the disc brake. The
example here shows the disc brake in the '12.00'
position.
Max. play 1.0 mm. If remedial measures
are required, see the brake manual.
RI 003-04/11
Section 1
Preliminary
-
25 -
Publicité
Table des Matières
