Table des Matières
Publicité
Checking slide pins bellows
Check each of the two protection caps (9) and six
bellows (12). Also check the two protection cups (71).
If there are signs of cracks or other damage, the
protection cups (71), bellows (12) and protection
caps (9) must be replaced!
If any action is necessary, see the brake manual.
Checking adjustment screws bellows
Turn the adjustment shaft using an 8 mm ring
spanner until thrust plate (28) is 45-50 mm out from
the cover (33).
IMPORTANT! thrust plate (28) max. 50 mm out from
cover (33)!
Inspect protection springs (30) (protection springs (30)
are optional). Now pull back the protection springs (30),
and inspect the bellows (32).
If there is any sign of cracks or other damage, the
protection springs (30)/bellows (32) must be replaced!
Turn adjustment shaft back fully. Check that
the protection springs (30) are correctly seated
so that they are not crushed or damaged!
If any action is necessary, see the brake manual.
The checks outlined in this section should be conducted
with brake pads (5) removed. See « Replacing brake pads »
for instructions regarding the fitting of brake pads.
RI 003-04/11
Section 1
Preliminary
-
27 -
Publicité
Table des Matières
