Dräger 7000 Notice D'utilisation page 41

Component Description
Water The water heating can only be activated if:
the doors are closed and locked,

the level sensor LS2 detects water and

the temperature is not above +66 °C.

As soon as the heating in the vat is
activated, the temperature continues to
rise until deactivated.
Above +66 °C the heating switches off and
the wash procedure is stopped. When the
temperature falls below +66 °C, the error
can be acknowledged and the wash
procedure can be continued again.
Cabin Indication of the actual temperature in the
cabin
Dosing pump 1, The dosing pump can only be activated if:
2 and 3 (2 and 3 the doors are closed and locked and

are optional) the sensor in the relevant detergent/

disinfectant container detects liquid.
4.3.5 Program library
The pre-installed wash procedures and the personalized wash
procedures can be viewed in the program library.
NOTICE
► The test program and wash procedures 2 to 12 are proce-
dures pre-installed by Dräger, and cannot be modified.
► The personalized wash programs can only be created and
modified by the Admin user.
► The relevant detergents/disinfectants are specified after
each Dräger pre-installed wash procedure.
Explanation of the pre-installed wash procedures:
Wash procedure Description
Dräger test test program
program
Dräger CPS Wash procedure for Dräger CPS
Dräger masks/LDV Wash procedure for Dräger masks/LDV
Dräger SCBA Wash procedure for Dräger self-
contained breathing apparatus
Dräger helmets Wash procedure for Dräger helmets
1. In the upper area it is possible to switch between wash
procedures 1-10 and 11-20.
2. Select the wash procedure. To do this, select the gray
circle in front of the relevant wash procedure.
3. The selected wash procedure is then opened by tapping
the newly revealed
The selected wash procedure is opened and the settings are
displayed.
Frame type Indication of which trolley must be used for
the wash procedure. If, for example, the full
face mask or combination trolley must be
used, "MA/LDV" is displayed.
Detergent/ Indication of the percentage of detergent/
disinfectant 1, disinfectant used for the wash procedure
2 and 3 in % (2 (range selectable from 0.0 to 99.9 %).
and 3 are
optional)
Step name Name of the respective step
Water temp. Indication of the target water temperature set
for the respective step (range selectable from
0 to +60 °C).
Air temp. Indication of the target air temperature set for
the respective step (range selectable from 0
to +60 °C).
Cabin nozzles Indication of whether the spray nozzles in the
cabin are active during this step.
Frame nozzles Indication of whether the spray nozzle on the
trolley is active during this step.
Pulse/pause Indication of whether the Pulse/pause mode
for the spray nozzles in the cabin or the trolley
was activated during this step.
Pulse time Time for how long the respective pulse lasts.
A pulse with a time of 0 seconds is not
executed (range selectable from 0 to 255
seconds).
Step time Indication of the operating time set for the
respective step (range selectable from
0 to 999 minutes).
4. To modify a personalized wash procedure,
the Admin must be logged in,

the wash procedure must be opened and

the button at the bottom right must be operated.

Operation
button.
en
41