Hella Gutmann SEG V Mode D'emploi page 99

Hella Gutmann
7. Device configuration
Configure all interfaces and functions under >Settings< in the main menu.
7.1. Entering Vehicle Data
Enter data for the quick test and the documented test here.
Proceed as follows to enter or to change vehicle data:
1. Select Settings > Measurement in the main menu.
2. Open the list under Vehicle type with
3. Select a vehicle type.
The selection will be saved automatically.
4. Open the virtual keyboard under Inclination in % with
The percentage value for the inclination is generally specified on headlight. This value (e.g. 1%) means that the low
beam tilts by 10 cm within a 10 m distance.
5. Enter the required value.
6. Close the virtual keypad with
The input will be saved automatically.
7. Repeat the steps 4 to 7 for Front fog lamp inclination in %.
8. Open the list under Driving direction with
9. Select >Left-hand traffic< or >Right-hand traffic<.
ð The inputs will be saved automatically.
7.1.1. Configuring the Light Measurement Unit
Proceed as follows to configure the light measuring unit:
1. Select Settings > Measurement in the main menu.
2. Open the list under Light measuring unit with
3. Select >Lux< or >Candela<.
Lux (receive size) is the illumination level and measures, how much light arrives on a certain surface from a light
source.
Candela (send size) is the light intensity and describes the luminous flux, that is emitted from a light source in a specific
direction.
SEG V
.
.
.
.
.
Device configuration | 7.
99