Hella Gutmann SEG V Mode D'emploi page 126

8. | Working with the Device
16. If required, change the data as described in the section Entering Vehicle Data [} 99].
17. Open the Headlight selection window with
18. Perform the headlight test as described in the section Performing headlight test [} 130].
19. Use to call up the selection window Finish documented test?.
20. Use the selection window to:
finish the measurement
finish the measurement and send it to the pen drive
finish the measurement and send it per e-mail
NOTICE
The message Finish measurement and send it per e-mail is only indicated if the Wi-Fi interface is config-
ured.
21. Regard the window with information and instructions.
22. Finish the measurement with
23. Abort the procedure with
ð The data from the documented test are automatically saved in Car History.
8.4.4. Managing Car History Entries
The Car History provides an extended search function according to a specific time period and it is also possible to send and
delete single or several entries.
Send and delete single or several entries by using the checkbox under Multiple selection:. The activated checkbox is
marked with green square inside it.
The second checkbox becomes visible after having activated the first checkbox. By activating the second checkbox you are
able to select or unselect already registered entries at the same time. A selected entry is marked with a green line.
Uncheck your selection by deactivating the second checkbox.
Open the Selection window with
1. Perform measurement
Indicated only if an entry is selected
2. Send reports to pen drive
3. Send reports to e-mail address
4. Delete reports
5. Delete vehicle owner
ð All entries to the selected vehicles are displayed if you select one out of the points 2 to 5. In this menu the multiple se-
lection function is identical to the one in the previous menu.
126
.
.
.
. Do the following here:
Hella Gutmann
SEG V