Hella Gutmann SEG V Mode D'emploi page 124

8. | Working with the Device
10. Confirm the selection with
NOTICE
The documented test can only be done if you have entered the vehicle registration number and the vehicle
owner.
11. Open the virtual keypad under Registration number with
12. Enter the vehicle registration number.
13. Close the virtual keypad with
The input will be saved automatically.
14. Repeat steps 11-13 for the vehicle owner and VIN.
15. Confirm the inputs with
The Target specifications window appears.
16. If required, change the data as described in the section Entering Vehicle Data [} 99].
17. Open the Headlight selection window with
18. Perform the headlight test as described in the section Performing headlight test [} 130].
19. Use to call up the selection window Finish documented test?.
20. Use the selection window to:
finish the measurement
finish the measurement and send it to the pen drive
finish the measurement and send it per e-mail
NOTICE
The message Finish measurement and send it per e-mail is only indicated if the Wi-Fi interface is config-
ured.
21. Regard the window with information and instructions.
22. Finish the measurement with
23. Abort the procedure with
ð The data from the documented test are automatically saved in Car History.
124
.
.
.
.
.
.
.
Hella Gutmann
SEG V