Hella Gutmann SEG V Mode D'emploi page 104

7. | Device configuration
2. Open the list under Automatic display dimming with
3. Select >On< or >Off<.
If >On< is selected, the display brightness will be automatically dimmed to the minimum brightness value after 5 min-
utes of inactivity.
ð The selection will be saved automatically.
7.6.3. Automatic switching off when inactive
Proceed as follows to activate or deactivate the automatic display dimming in case of inactivity:
1. Select Settings > Device >Save energy in the main menu.
2. Open the list under Automatic display dimming in case of inactivity with
3. Select >On< or >Off<.
The SEG V will switch off automatically after 30 minutes if >On< is selected.
ð The selection will be saved automatically.
7.6.4. Calibrate touch screen
Proceed as follows to calibrate the touch screen:
1. Select Settings > Device > Extended in the main menu.
2. Start the calibration process with
3. Regard the window with information and instructions.
4. Activate the calibration with
Five calibration points are displayed consecutively.
5. Choose the five calibration points.
The selection will be saved automatically. The device switches off and on again automatically. This may take a few sec-
onds.
ð The touch screen is now recalibrated.
7.6.5. Save diagnostic data
Use this function to save diagnostic data on a pen drive in case of troubles.
Proceed as follows to save diagnostic data:
1. Insert a pen drive into the USB port on the SEG V.
2. Select Settings > Device > Extended in the main menu.
3. Open the list under Save diagnostic data with
4. Select USB and start saving with
ð The Technical Help Line of Hella Gutmann requires the diagnostic data for troubleshooting.
104
in the menu Calibrate touch screen.
. Abort the procedure with
.
. Observe the information window.
.
.
.
Hella Gutmann
SEG V