Hella Gutmann SEG V Mode D'emploi page 85

Hella Gutmann
2.1.4. Safety Precautions – Risk of Injury
When working on the vehicle, there is a risk of injury through rotating parts or rolling of the vehicle. Therefore regard the
following:
• Protect vehicle against rolling away.
• Additionally place gear selector lever of AT vehicles to park position.
• Deactivate the start/stop system to avoid an inadvertent engine startup.
• Connect the product to the vehicle only when ignition is switched off.
• Do not reach into rotating parts while the engine is running.
• Do not run cables near rotating parts.
• Check the high-voltage parts for damage.
2.1.5. Safety Precautions – Chemical Burns
If the TFT display is damaged, there is a danger of chemical burns due to the escape of liquid crystal. Therefore regard the
following:
• Immediately rinse affected parts of the body or clothing with water (consult a doctor).
• Seek medical attention immediately after inhaling or swallowing.
2.1.6. Safety Precautions – Laser Sight
The laser sight corresponds to laser class 2.
There is a risk of injury through dazzling the eyes when working with the laser. Therefore regard the following:
• Only use the laser in connection with the mounted protective shields.
• Replace defective protective shields instantly.
• Do not direct the laser beam towards persons, doors or windows.
• Never look directly into the laser beam.
• Only use the laser sight for the intended purpose.
SEG V
User Information | 2.
85