Hella Gutmann SEG V Mode D'emploi page 115

Hella Gutmann
*In case of vehicle hoists, measure the distance is taken from the front edge of the optical housing to the front edge of the
vehicle hoist.
Fig. 2: Tolerance
• The dimensions for the set-up area for vehicles as well as the SEG V must correspond to fig. 1. The unevenness of the
set-up area for the SEG V must be max. ± 1 mm/1 m. The tolerances of the set-up area for vehicles are specified as in
fig. 2 (source of figues: Verkehrsblatt 11/2018).
• The set-up areas for the vehicle and the SEG V must be clearly marked e.g. through floor markings.
8.2.2. Setup Area for Stationary SEG V
NOTICE
The ground must comply with the requirements of Eurocode 2/DIN EN 1992 and the concrete must corre-
spond to the compression strength class C20/25.
The area around the rail system has to be marked as a hazardous area (risk of tripping) (DIN 4844-1). This
must be taken into account when assessing the hazards in the workplace.
Up to device no. 2272
SEG V
Working with the Device | 8.
115