Hella Gutmann SEG V Mode D'emploi page 128

8. | Working with the Device
finish the measurement
finish the measurement and send it to the pen drive
finish the measurement and send it per e-mail
NOTICE
The message Finish measurement and send it per e-mail is only indicated if the Wi-Fi interface is config-
ured.
20. Regard the window with information and instructions.
21. Finish the measurement with
22. Abort the procedure with
ð The data from the documented test are automatically saved in Car History.
8.4.6. Creating a Report
The report of the documented test can be saved on a pen drive or it can be sent per e-mail to another device.
To save the report on a pen drive, proceed as follows:
1. Insert a pen drive into the USB port on the SEG V.
2. Perform the steps 1 to 6 as described in section Performing Documented Tests from the Car History [} 125].
3. Select >Send report<.
The report is saved as a PDF file on the pen drive.
The report contains the following information:
• Company data
• Customer and vehicle data
• Device type
• Date and time of the headlight test
• Test results before headlight adjustment
• Test results after headlight adjustment
NOTICE
First configure the interfaces before you can send the report per e-mail. For this perform the steps as de-
scribes in section Configuring interfaces [} 108].
Now the following fault messages during e-mail sending may appear despite correctly configured interfaces:
• The device is not registered at Hella Gutmann. Please contact the Hella Gutmann Help Line.
• Registration was not successful. Please check the time and date settings. Please contact the Technical Help Line of Hella
Gutmann if the problem occurs again.
128
.
.
Hella Gutmann
SEG V