Hella Gutmann SEG V Mode D'emploi page 129

Hella Gutmann
8.5. Quick test
In the quick test, headlights can be checked without entering specific vehicle data. The headlight settings must be known
for the vehicle. The result of the test cannot be saved.
8.5.1. Preconditions for a Quick Test
Ensure the following to perform a quick test:
• The steps in the sections Preparing headlight test [} 114] and Aligning the SEG V [} 120] are performed com-
pletely.
8.5.2. Performing Quick Tests
Proceed as follows to perform the quick test:
1. Select >Quick test< in the main menu.
2. Observe the info window where necessary.
3. Confirm the info window with
The Target specifications window appears.
4. If required, change the data as described in the section Entering Vehicle Data [} 99].
The headlight setting data shall correspond to the manufacturer's specifications.
5. Open the Headlight selection window with
6. Perform the headlight test as described in the section Performing headlight test [} 130].
8.6. Measured value calibration
Check the inclination calibration here. For this you can switch on or off the level sensor of the SEG V.
8.6.1. Switching On the Level Sensor
The level of the vertical and horizontal axis adjusts automatically in a way that any irregularity in the SEG V set-up area is
compensated if the level sensor is switched on.
Proceed as follows to switch on the level sensor:
1. Select >Measured value calibration< in the main menu.
The window Measured value calibration appears.
2. Open the list under Level compensation with
3. Select >on<.
The SEG V is balanced from a measuring technology standpoint.
Perform the horizontal/vertical calibration with
Abort the procedure with
SEG V
where necessary.
.
.
.
.
Working with the Device | 8.
129