Hella Gutmann SEG V Mode D'emploi page 108

7. | Device configuration
7.8. Service menu
The >Service menu< is exclusively reserved for Hella Gutmann service technicians or the testing organizations.
7.9. Configuring interfaces
Make your WLAN and e-mail settings here.
Wi-Fi is a wireless local area network. Data is transmitted wirelessly via a router and DSL modem (access point). The re-
spective devices register in the Wi-Fi router.
7.9.1. Searching and Installing a Wi-Fi Interface
Proceed as follows to connect the device to a network (router) via Wi-Fi interface:
1. Select Settings > Device > Interfaces > Network in the main menu.
2. Open the list under IP address mode with
If >Determine automatically (DHCP)< (recommended) is selected, the DHCP server of the network will assign an IP
address to the SEG V automatically. This option is set ex works.
If >Manual< is selected, then go to SEG V – IP address and enter a free IP network address, e.g.: Network mask
192.168.246.002 / Standard gateway: 192.168.204.2.
3. Select >Determine automatically (DHCP)< (recommended) or >Determine manually<.
The selection will be saved automatically.
4. Create wireless network with
The Wi-Fi connection search is active.
Once the device has successfully finished the search for a Wi-Fi connection, a drop-down list of Wi-Fi networks found is
displayed.
5. Select a Wi-Fi network.
6. Confirm the selection with
7. Open the virtual keypad with
8. Enter the Wi-Fi password.
9. Close the virtual keypad with
10. Confirm your input with
The input will be saved automatically.
If the connection to the Wi-Fi network was successfully set up, the name of the selected Wi-Fi network is shown under
Wireless network (SSID).
ð Now you can start working with Wi-Fi connection.
7.9.2. Test Wi-Fi configuration
Proceed as follows to test the Wi-Fi configuration:
108
.
.
.
.
.
.
Hella Gutmann
SEG V