Hella Gutmann SEG V Mode D'emploi page 91

Hella Gutmann
1. Loosen the hand wheel of the column locking mechanism (12).
2. Rotate the optical housing (8).
3. Tighten the hand wheel of the column locking mechanism.
3.6. Switching On the Laser
CAUTION!
Laser radiation
Damage to/destruction of the retina
Never look directly into the laser beam.
NOTICE
After switching on the laser, the laser output is activated for approx. 30 s via an integrated interval timer.
Within this time you can align the SEG V in front of the vehicle.
Proceed as follows to switch on the laser module:
1. Briefly push the ON/OFF button of the laser module (1).
The laser is activated for approx. 30 s.
2. If required, repeat step 1 to reactivate the laser.
ð Now, you can align the device in front of the vehicle.
3.7. Adjusting the Height of the Laser Sight
To adjust the height of the laser sight, proceed as follows:
1. Loosen the hand wheel of the laser sight (11).
2. Set the desired height.
3. Tighten the hand wheel of the laser sight.
3.8. Adjusting the Inclination of the Laser Sight
To adjust the inclination of the laser sight, proceed as follows:
1. Loosen the pinch bolt of the laser sight (17).
2. Set the desired inclination.
3. Tighten the pinch bolt of the laser sight.
SEG V
Product Description | 3.
91