Hella Gutmann SEG V Mode D'emploi page 107

Hella Gutmann
All customer-specific data records will be reset if you perform the factory reset.
Proceed as follows to perform a factory reset:
1. Select Settings > Device > Extended in the main menu.
2. Use to start the factory reset under Start factory reset.
Observe the confirmation prompt.
3. Confirm the confirmation prompt with
The device will be automatically reset to the state of delivery.
7.7. Updating the Device
Perform device updates here. Various system parameters are also displayed, e.g.:
• Software version
• Hardware version
• Device number
Hella Gutmann Solutions supplies customers with software updates at varying intervals. These updates contain techni-
cal modifications and improvements. We recommend keeping your device up to date with these updates.
7.7.1. Preconditions for an Update
Ensure the following to perform updates:
• Voltage supply of the device is ensured.
7.7.2. Starting the Software Update
Start the update of the device's software here.
Proceed as follows to start the software update:
1. Select Settings > Update in the main menu.
CAUTION!
Insufficient voltage supply
System data loss
Do not switch off the device during the update and do not disconnect it from voltage supply.
Ensure sufficient voltage supply.
2. Start the update with
The device searches for a new update, the files will then be downloaded and installed.
ð The device switches off and on again automatically after the successful software update.
SEG V
.
.
Device configuration | 7.
107