Hella Gutmann SEG V Mode D'emploi page 122

8. | Working with the Device
8.3.3. Adjusting the Height of the Laser Sight
The laser sight provides the option to align the SEG V and headlights using a laser pointer. Two parallel points on the vehi-
cle front can be detected with the generated light band. If the required power supply (9 V block battery, 9 V type) is not
available, then the alignment can be carried out using the broad-band sight.
NOTICE
Devices with rubber castors must be individually aligned for each headlight to be tested. Devices on rails
need to be aligned only once per vehicle.
The targeted points on the vehicle must be significantly below the height of the sight.
To adjust the height of the laser sight, proceed as follows:
1. Loosen the hand wheel of the laser sight (11).
2. Set the desired height.
3. Tighten the hand wheel of the laser sight.
8.3.4. Aligning the Optic Housing on Commercial Vehicles
Fig. 7:
122
Hella Gutmann
SEG V