Hella Gutmann SEG V Mode D'emploi page 123

Hella Gutmann
In individual cases, when aligning commercial vehicles and buses with the SEG V, difficulties may arise with heavily arched
front sections. If this is the case, then use a plumb bob or other suitable object to transfer the headlight centres to the
ground and detect them with the sight (see Figure 7).
8.4. Documented test
Use this function to retrieve data from the vehicle database or from the Car History. Moreover, it is possible to create a
vehicle entry manually. The test results can be assigned to a licence plate number and vehicle owner and the results can
be stored. If needed, the test result can be saved as a report onto a pen drive or it can be sent by e-mail.
8.4.1. Preconditions for a Documented Test
Observe the following to perform documented tests:
• The steps in the sections Preparing headlight test [} 114] and Aligning the SEG V [} 120] are performed com-
pletely.
8.4.2. Performing Documented Tests from Vehicle Database
NOTICE
A documented test can only be done when the company data has been entered.
To perform a documented test from the vehicle database, proceed as follows:
1. Select >Documented test< in the main menu.
2. Observe the info window where necessary.
3. Confirm the info window with
The Vehicle selection window is displayed.
4. Choose to call up the vehicle database.
NOTICE
You need to select at least the manufacturer, the fuel type and the model.
5. Select the requested manufacturer.
6. Select the requested fuel type.
7. Select the requested model.
8. Confirm the selection with
If all vehicle data is not selected, then a drop-down list is displayed.
9. Select the requested vehicle type.
SEG V
where necessary.
.
Working with the Device | 8.
123