Programming The Machine Parameters (Display); Accessing The Menu; Machine Alarms - Astoria Core600 AL Manuel D'utilisation Et D'entretien

6.12 Programming the machine parame-
ters (DISPLAY version)

6.12.1 Accessing the menu

To access the machine's programming modes and where the
data can be viewed, touch the display twice.
Select the various buttons to access the sections indicated in
the following paragraphs.
The system automatically exits the programming
mode 20 seconds after the last operation was car-
ried out.
Always use the right pushbutton panel for the programming
modes.
Machine
alarms
Automatic steam wand/
cup warmer temperature
Heating unit pressure
Language
settings
Work
count
52 216
of
45°C
Energy saving
mode
Standby and
programming
Machine
working hours

6.12.2 Machine alarms

To view the machine alarms, press the
Select the button to view the machine's current warn-
ings (see the list below).
Should any of these occur, call out the Technical Support Ser-
vice by calling the number shown on the display.
To exit, press the button.
Warnings
Steam heating unit temperature
probe has overheated or short-
circuited
Steam heating unit temperature
probe is disconnected or cut off
Cup warmer temperature probe
has overheated or short-circuited
Cup warmer temperature probe
is disconnected or cut off
Steam nozzle probe
has short-circuited
Steam nozzle probe is
disconnected or cut off
Fillingup timeout warning
Select the button to view the machine's alarm history.
To exit, press the button.
Should an alarm occur, call out the Technical Sup-
port Service by calling the number shown on the
display and turn off the machine.
button.
Alarm timeout Fill-out
Tel. 00000000000
Alarm
Warning data is corrupted
Change filter warn-
ing (90% worn)
Filter completely worn warning
Maintenance warning
Heating unit heating
timeout warning
Volumetric counter warn-
ing for each group
1/1
24/01/17 15:09:29 Filter reset 100%
24/01/17 15:09:29 Filter reset 90%
USER Manual