Astoria Core600 AL Manuel D'utilisation Et D'entretien page 59

Problem
THE COFFEE GROUNDS ARE WET
THE GAUGE INDICATES A
NON-CONFORMING PRESSURE
COFFEE GROUNDS
FOUND IN CUPS
THE CUP IS DIRTY WITH
COFFEE SPLASHES
ALL THE PUSHBUTTON PANEL
LEDS ARE FLASHING (SAE version)
TIME-OUT LED SWITCHED
ON (AEP version)
THE COFFEE IS
NOT BEING DISPENSED
CORRECTLY
THE COFFEE DOSE
IS NOT CORRECT
THE DOSE BUTTON
LED IS FLASHING
COFFEE IS ONLY DISPENSING
VIA THE MANUAL BUTTON
THE ELECTRONIC SYSTEM
HAS SHUTDOWN
WATER IS LEAKING
FROM THE PUMP
THE MOTOR STOPS
SUDDENLY OR THE THERMAL
PROTECTOR IS TRIGGERED
BY A POWER OVERLOAD
THE PUMP IS WORKING BELOW
THE NOMINAL FLOW RATE
THE PUMP IS NOISY
USER Manual
Cause
The dispensing group is dirty.
The dispensing group is too cold.
The coffee has been ground too finely.
The coffee is too old.
Hydraulic system fault.
The filter holder is dirty.
The filter holes are worn.
The coffee has not been ground evenly.
The coffee has been ground too coarsely.
The filter's edge is damaged.
After a few minutes the water stops being automat-
ically filled.
The timeout device has cut in.
There is no water in the mains.
The coffee has been ground too finely.
Electronic system fault.
Electrical system or hydraulic system fault.
Pump fault.
Pump fault.
Pump fault.
Pump fault.
Action
Wash the group with the blind filter.
Wait for the group to fully heat up.
Adjust the coffee grinding.
Replace with fresh coffee.
Turn off the machine and call out the Technician.
Clean the filter holder.
Replace the filter.
Adjust the grind as appropriate.
Adjust the coffee grinding.
Replace the filter.
Turn the machine off and then back on.
Open the water mains valve.
Adjust the coffee grinding.
Turn off the machine and call out the Technician.
Turn off the machine and call out the Technician.
Turn off the machine and call out the Technician.
Turn off the machine and call out the Technician.
Turn off the machine and call out the Technician.
Turn off the machine and call out the Technician.
59 216
of