Programming The Coffee Dispenses On The Sae And Display Versions; Displaying Information; Dispensing Steam - Astoria Core600 AL Manuel D'utilisation Et D'entretien

Programming the coffee dispenses
6.5.5
on the SAE and DISPLAY versions
Each dose must be programmed with freshly
ground coffee and not with previously-used coffee
grounds.
The machine is programmed by default. Should the coffee
doses need to be modified, proceed as follows:
• Always programme the right push-
button panel first. This way, all the
pushbutton panels will be automati-
cally programmed. If necessary, sub-
sequently programme the others.
• Place the cup under the dispensing
spout.
• Press the button for at least 5
seconds, until all the dose button
LEDs are lit.
• Press the desired dose button, for
example .
• To confirm the dose, press the
button again or the
• Repeat this operation for the other
dose buttons.
• When the programming is complete,
press the button until all of the
LEDs on the pushbutton panel go
off.
All the groups will now be pro-
grammed this way. Should
you wish to programme them
differently, proceed to singularly pro-
gramme the left-hand groups one by
one as illustrated above.
48 216
of
button.

Displaying information

6.5.6
A series of information is shown on the display whilst coffee
is being dispensed.
Heating unit
pressure mains pressure
Dispensing time count
for each group

6.6 Dispensing steam

Carefully move the steam
nozzle using the specific an-
ti-scald rubber grip (1).
Do not direct the steam to-
wards hands or other parts of the body.
Do not touch the steam nozzles with
bare hands; use the appropriate PPE.
Before using the steam
nozzle, the condensation
draining operation
always be carried out for at least 2
seconds.
• Immerse the steam nozzle into the
liquid to be heated.
• Rotate the valve knob anticlockwise.
• The quantity of steam will be
proportional to how open the valve
is.
• To stop dispensing, turn the valve's
knob clockwise.
Water Time and
date
must
1
USER Manual