Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
To optimally froth the milk, follow these simple rules:
• Only heat the amount of milk that you intend to use; once
heated, it will have to be completely poured out of the jug
and cannot be reheated.
• Froth the milk starting with a temperature of about 4°C.
To keep the steam nozzle tips in perfect working
order, it is advisable to carry out a brief dry dis-
pensing run after each use. Keep the tips clean at
all times using a cloth dampened in lukewarm water.
Only leave the steam nozzle immersed in the milk for the
time needed to heat it.
Do not open the steam valve with the steam wand
immersed in milk and the machine switched off, as
the latter would suck milk into the pipes.
6.7 Dispensing hot water
Danger of scalding. Do not direct hot water to-
wards hands or other parts of the body. Do not
touch the hot water nozzle with bare hands; use
the appropriate PPE.
6.7.1
AL and AEP versions
• Place the pot under the hot water
spout.
• Rotate the valve knob anticlock-
wise.
• The hot water flow will be propor-
tional to how open the valve is.
• To stop dispensing, turn the valve's
knob clockwise.
USER Manual
6.7.2
SAE and DISPLAY versions
• Place the pot under the hot water
spout.
• Press the water button
for the hot water to be dispensed.
• To stop the dispensing ahead of time,
press the hot water dispensing button
again
or press the
Programming the
6.7.3
hot water on the
SAE and DISPLAY
versions
The machine is programmed by default.
Should the hot water doses need to be
modified, proceed as follows:
• Place the pot under the hot water
spout.
• Press the
button for at least 5
seconds, until all the dose button
LEDs are lit.
• Press the
button
• To confirm the dose, press the
button again.
• When the programming is com-
plete, press the
button until
all of the LEDs on the pushbutton
panel go off.
and wait
button.
49
216
of
Publicité
Chapitres
Table des Matières
