Swinging Flap - BÖCKMANN KK 3015/27 H Mode D'emploi

4 Features
4.10.2 Loading ramps
The following loading ramps can be
used:
– Basic version of loading ramp (A)
– Two-section loading ramp (B)
A Basic version of loading ramp
Fig. 48: Basic version of loading ramp
B Two-section loading ramp
Fig. 49: Two-section loading ramp
The two ramp sections are connected to
each other with hinges.
Folding down the loading ramp
1. Release the side clamps securing the
loading ramp.
Operating Instructions
2. Swing down the loading ramp, fold
out the second half and slowly lower
to the ground or support surface.
3. Make sure the loading ramp is firmly
on the ground or support surface.
Folding up the loading ramp
1. Fold in the second half and then fold
up the whole loading ramp.
2. Fasten the side clamps to secure the
loading ramp.

4.11 Swinging flap

Uncontrollably falling load
• Only open the swinging flap on tip-
pers if the upper bridge is in non-
tipped state.
Fig. 50: Swinging flap on the tipper
39