Bahco BBA1224-3200 Manuel Du Propriétaire page 4

3. INSTRUCTION MANUAL
3.1. TO START A VEHICLE
Turn OFF ignition before using the Booster.
1. The tension selector must be disconnected !**
2. How to connect your Booster
A. Starting in 12V
Connect the red clamp (+) to the positive terminal (+) of the battery, then connect
the blue clamp (-) to the negative (-) terminal of the battery.
B. Starting in 24V
-> Read point 3.2.: detection of 24V
• If the batteries are side by side: Connect the red clamp (+) to the positive
terminal (+) of the battery, then connect the blue clamp (-) to the negative (-)
terminal of the other battery.
• If the batteries are on both sides of the vehicle: Connect the red clamp (+)
to the positive terminal (+) of the battery, then connect the blue clamp (-) to the
mass of the vehicle.
3. Selection of the tension
Select the tension of the vehicle to start ** -> from this moment there is current on
the clamps.
4. Start the engine
Turn the ignition key for a maximum of 8-10 seconds, wait for a further 3 minutes
before attempting to start again.
5. Disconnection of the tension
After starting, disconnect the tension selector.
6. Disconnection
Disconnect the blue (-) clamp first, followed by the red (+) clamp.
7. Storing
Return the cables and clamps to their support posts.
8. Recharging
Recharge the Booster immediately after use !
** Importantt !!! -> See point 4.2. (point 5.): Explosion risk
• •
4