Bahco BBA1224-3200 Manuel Du Propriétaire page 16

3. OPERATION INSTRUCTIONS
When you are sure that the charging plug is correctly connected, connect the power cord
to the power outlet and push the START/STOP button. If the latter is not pressed, charging
should begin in then minute's time. The charger starts and resets itself automatically.
The charging LED's will indicate the charging progress.
To disconnect the charger from your booster, push the START/STOP button. Remove the
AC cord from the electric outlet and disconnect the charger from the booster.
4. TROUBLESHOOTING
PROBLEM
The POWER LED
doesn't light when charger is
properly connected.
The booster is correctly
connected, but the Charging
LED didn't light
immediately.
The booster is properly
connected, but the Charging
LED never lit.
The Battery Defect
LED is lit and the
Charging LED
is flashing.
The Battery Defect
LED is lit.
POSSIBLE CAUSE
AC outlet is dead.
Bad electrical connection.
If the START/STOP button is not
pressed, charging should begin in
ten minute's time.
The voltage of the booster batteries
is very low.
The voltage of the booster batteries
is below 10V after 2 hours of
charging.
Desulfation was unsuccessful.
The booster batteries are sulfated.
Lack of progress is detected and
booster batteries voltage is below
14.2V.
The batteries voltage drops to
below 12.2V in Maintain Mode.
• •
16
REASON/SOLUTION
Check for open fuse or circuit
breaker supplying AC outlet.
Check power cord and extension
cord for a loose or damaged fitting
plug.
No problem, this is normal.
Press the START/STOP button to
start charging.
The booster batteries may be
defective. Make sure there are no
loads on the batteries. If there are,
remove them. If there are none,
have the batteries checked or
replaced.
The batteries may be defective.
Have batteries checked or
replaced.
The charger is in desulfation mode.
Continue charging for 24 hours. If
not successful, have the booster
batteries checked.
The batteries may be overheated.
If so, allow the batteries to cool.
Have battery checked or replaced.
The battery won't hold a charge.
May be caused by a drain on the
batteries or the batteries could be
bad. Make sure there are no loads
on the batteries. If so, remove
them. If not, have the batteries
checked or replaced.