Bahco BBA1224-3200 Manuel Du Propriétaire page 15

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 18
• Do not replace/modify the original AC plug/cord. Call a qualified electrician if
needed.
• Do not cover the charger.
• If your booster has been stocked or used at negative temperatures, do let
it heat-up to room temperature before charging it. Do not recharge frozen
battery.
• Do not attempt to charge a damaged booster's battery. If the supply cord
is damaged or if you notice any damage on the unit, it must be replaced by
the manufacturer, its service agent or similarly qualified persons in order to
avoid a hazard.
• Never recharge the booster if the clamps are not stored on their support on
the booster's case.
• Connect and disconnect charging plug to/from the booster only after
removing AC cord from electric outlet.
• Never pull on the AC cord to remove the AC plug from the mains. This may
damage the cord or the plug.
• Disconnect the charger before any cleaning or maintenance.
• If the charger has not gone to maintenance charging within 3 days, the
charger and the booster must be disconnected and verified by a qualified
person. It may be that the booster's batteries are sulfated.
2. CONTROL PANEL
START/STOP BUTTON
Press to immediately start charging your properly connected booster. If the button is not
pressed, charging should begin in ten minute's time.
POWER LED (green)
The charger is connected to an AC outlet.
Charging LED (orange) lit
The booster is charging.
Charging LED (orange) flashing
The booster is not charging because the charger has detected a problem. The "defect" LED
will also light up (refer to point 4 "Troubleshooting").
Charged/Maintaining LED – GREEN pulsing
The booster is fully charged. The charger gets in float charging mode to maintain the battery
capacity.
Battery Defect LED (red)
The charger has detected a problem with the booster batteries. Those might be damaged or
sulfated. In the above case, please contact your retailer (refer to point 4 "Troubleshooting").
Faulty Charging Circuit LED
The charging circuit is in reverse polarity, please contact your retailer.
15

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Bba1224-3200-chg

Table des Matières