Hot Water; Dispensing Hot Water; Programming The Hot Water; Dispensing With The Steam Wand - Astoria Sabrina SAE Manuel D'utilisation Et D'entretien

To keep the steam nozzle tips in perfect working
order, it is advisable to carry out a brief dry dis-
pensing run after each use. Keep the tips clean at
all times using a cloth dampened in lukewarm water. Only
leave the steam wand immersed in the milk for the time
needed to heat it.
Do not open the steam valve with the steam wand
immersed in milk and the machine switched off, as
the latter would suck milk into the pipes.

6.7 Hot water

6.7.1

Dispensing hot water

Danger of scalding. Do not direct hot water to-
wards hands or other parts of the body. Do not
touch the hot water nozzle with bare hands; use
the appropriate PPE.
• Place the jug under the hot water nozzle.
• Press the water button
be dispensed.
• The machine dispenses a programmed quantity of hot
water; to stop it from dispensing ahead of time, press the
hot water dispensing button
button.

Programming the hot water

6.7.2
The machine is programmed by default. Should the hot water
doses need to be modified, proceed as follows:
• Place the pot under the hot water spout.
• Press and hold the
at least 5 seconds: the button will start to flash.
• Press the hot water dispensing button
pensing.
• When the desired amount of water has been reached,
press the button again to confirm the dose.
• When you have finished programming, press the
ton to exit.
USER Manual
and wait for the hot water to
again or press the
button (the rightmost keypad) for
to start dis-

6.8 Dispensing with the Steam wand

6.8.1

Tips regarding its use

• Only froth the amount of milk that you intend to use; once
heated, the milk will have to be completely poured out of
the jug and cannot be reheated.
• The steam wand only guarantees an accuracy of ± 3°C be-
tween the set temperature and the actual milk tempera-
ture, if the starting milk temperature is 4°C.
• As the steam automatically stops dispensing when the set
milk temperature is reached, only fill the jug half way in
order to prevent the milk froth from spilling out.
• Use a suitably-sized jug for the amount of milk that re-
quires frothing (approx. 200 ml is recommended) and
make sure that it is circular and not conical (see the im-
age).
6.8.2

Dispensing

Do not direct the steam towards hands or other
parts of the body. Do not touch the steam nozzles
with bare hands; use the appropriate PPE.
• Immerse the steam wand nozzle tips (1) into the milk.
1
2
• Press the or
• Wait until the dispensing process has been completed.
• To stop dispensing ahead of time, press the same
but-
button again.
Keep the tips clean at all times using a cloth damp-
ened in lukewarm water. Milk can be kept in the
fridge for a maximum of 3-4 days.
Sabrina
button on the pushbutton panel (2).
or
43 260
of