Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
7.5.4
Dispensing group wash
SAE version
The washing operations can also be carried out si-
multaneously on multiple dispensing groups. To
exit the washing phase, the washing procedure
must have been completed on all groups.
Wash the dispensing groups on a daily basis as indicated be-
low:
• Remove the filter from the filter holder and fit a blind filter
(see the standard supplied parts).
• Press and hold the double espresso button
the pushbutton panel of the group that you would like to
clean, for 10 seconds until the button's LED starts to flash.
• Pour the specific cleaner (see spare parts) into the filter
holder with the blind filter and hook it to the dispensing
group.
• Press the double espresso button
• Whilst the machine is performing the first wash cycle, the
(1) and
(2) button LEDs flash.
• When the first cycle has finished, the double espresso but-
ton LED
(2) will flash: remove the filter holder from
the group.
• Press the double espresso button
out the rinse procedure.
• Whilst the machine is performing the rinse cycle, the
(1) and
(2) button LEDs flash.
• Once the rinsing procedure has finished (approximately
30 seconds), the machine is ready to dispense normally.
1
2
3
7.5.5
Dispensing group wash SAE-
DISPLAY version
With this procedure, all of the groups are washed
at the same time; each keypad controls the refer-
ence group. To access the menu, please refer to
Paragraph "6.11.7 Dispensing group wash".
Wash the dispensing groups on a daily basis as indicated be-
low.
USER Manual
(2) on
(2) again.
(2) again to carry
4
5
6
To wash the dispensing groups, press the indi-
cated button.
To start the washing procedure, press the
"YES" button and proceed as follows:
Force washing
Are you sure?
Yes
1
2
3
• Remove the filter from the filter holder and fit a blind filter
(see the standard supplied parts).
• Pour the specific cleaner into the blind filters and attach
the filter holders to the dispensing groups.
• Press each group's double espresso button
• The "GROUP WASH IN PROGRESS" message will appear
on the display. Whilst the machine is performing the first
wash cycle, the button LEDs
• When the first cycle has finished, the double espresso but-
ton LEDs
(2) will flash: remove the filter holders from
the groups.
• Press the double espresso buttons again
out the rinse procedure.
• Whilst the machine is performing the rinse cycle, the
(1) and
(2) button LEDs flash.
• Once the rinsing procedure has finished (approximately
30 seconds), the machine is ready to dispense normally.
Sabrina
No
4
5
6
(2).
(1) and
(2) flash.
(2) to carry
51
260
of
Publicité
Chapitres
Table des Matières
