Using The Keypad E82Zbc − Parameter Setting; Displays And Operating Elements - Lenze 8200 vector Instructions De Montage

7
Commissioning
Using the keypad E82ZBC − Parameter setting
Description
The keypad is available as accessory. A full description of the keypad can be obtained from
the Instructions included in the keypad delivery.
Plugging in the keypad
It is possible to plug in the keypad onto the AIF interface or remove it during operation.
As soon as the keypad is supplied with voltage, it carries out a self−test. The keypad is ready
for operation if it is in display mode.
Front view

‚
88888
Hi
Lo

Displays and operating elements

0
Function keys
Press Function
key
u
Enable controller
s
Inhibit controller (CINH) or quick stop (QSP)
t
Change to function bar 1 « Function bar 2
xw
To right/left in active function bar
zy
Increase/decrease value
Quick change: Keep key pressed.
v
Parameters can be stored if
Confirmation by
114
8
PS
8888
888
m
Hz V A
%sh °C
Ω
rpm
E82ZBC002
p
blinking
STOre in the display
EDK82EV222 DE/EN/FR 10.1
Display mode
Œ
‚
5 000
Hi
Lo
Explanation
For operation with function module, the terminal X3/28
must be set to HIGH level
Configuration in C0469
The current function is framed
Only blinking values can be changed
1
PS
0050
000
Hz
E82ZBC003
L