Lenze 8200 vector Instructions De Montage page 85

1
Safety instructions
Transport, storage
Please observe the notes on transport, storage and appropriate handling.
Observe the climatic conditions according to EN 50178.
Installation
The controllers must be installed and cooled according to the regulation and instructions
given in the corresponding documentation.
Ensure proper handling and avoid mechanical stress. Do not bend any components and
do not change any insulation distances during transport or handling. Do not touch any
electronic components and contacts.
Controllers contain electrostatically sensitive components, which can easily be damaged
by inappropriate handling. Do not damage or destroy any electrical components since this
might endanger your health!
Electrical connection
When working on live drive controllers, the applicable national regulations for the
prevention of accidents (e.g. VBG 4) must be observed.
The electrical installation must be carried out according to the appropriate regulations (e.g.
cable cross−sections, fuses, PE connection). Additional information can be obtained from
the documentation.
The documentation contains information about installation in compliance with EMC
(shielding, grounding, filters and cables). These notes must also be observed for
CE−marked controllers. The manufacturer of the system or machine is responsible for the
compliance with the required limit values demanded by the EMC legislation.
Operation
Systems including controllers must be equipped with additional monitoring and protection
devices according to the corresponding standards (e.g. technical equipment, regulations
for prevention of accidents, etc.). If necessary, adapt the controllers to your application.
Please observe the corresponding information given in the Instructions.
After the controller has been disconnected from the supply voltage, live components and
power connection must not be touched immediately since capacitors could be charged.
Please observe the corresponding notes on the controller.
All covers and doors must be closed during operation.
Information for UL approved systems with integrated controllers: UL warnings are
notes which apply to UL systems. The documentation contains special information about
UL.
L
85
EDK82EV222 DE/EN/FR 10.1