Dc Docking Station - Vehicle - Ceteor Propulstation 12V/1200CA Mode D'emploi

A green LED is mounted on the top of your docking station and indicates the right connec-
tion of the Booster into the docking station.

2.6. DC docking station - Vehicle

Developed to be connected to the recovery vehicle's battery terminals, the simple fact of
putting the Booster back into its docking station allows it to be charged at 100% for the
next intervention.
Connection on the vehicle:
Connect the black cable to the negative terminal of the battery (or the earth).
n
Connect the red cable to the positive terminal of the battery.
n
-> For this, use the cables lugs provided for that purpose, if necessary.
A fuse of 15 or 20A can be mounted on the station circuit.
A green LED is assembled at the top of your docking station and indicates the recharge of
the Booster.
If you have connected your docking station to an auxiliary power supply in your vehicle, it
will be necessary to switch on the ignition or to run the engine to supply the station (green
LED).
A one-way diode installed on the docking station avoids the discharging of the Booster
towards the vehicle.
For a well charged Booster, the tension of the place where you connect the docking sta-
tion must be around 14,4V, engine running at about 2000 rpm.
EN
44