To Start A Vehicle - Ceteor Propulstation 12V/1200CA Mode D'emploi

3. Instructi on manual

3.1. To start a vehicle

1.
Connection
Connect the red clamp (+) to the positive terminal (+) of the battery, then connect the blue
clamp (-) to the negative (-) terminal of the battery.
2.
Start the engine
Turn the ignition key for a maximum of 8-10 seconds, wait for a further 3 minutes before
attempting to start again.
3.
Disconnection
Having started the engine, disconnect the blue (-) clamp 1st, followed by the red (+) clamp.
4.
Storing
Return the cables and clamps to their support posts on the Booster.
5.
Recharging
After use, put the Booster immediately back in its docking station !
1
3
45
Turn OFF ignition before using the Booster.
2
4
5