Dc Docking Station - Vehicle - Ceteor PropulStation Mode D'emploi

A support with a buttonhole allows the charger to be fixed next to the station; you will
be able to check at a glance that the Booster is charging.
If the light of the charger is:
Orange: your Booster is charging
Green: your Booster is charged
Red: the charging circuit is faulty. Warning: your Booster is not charging,
contact immediately your reseller.
A green LED is mounted on the top of your docking station and indicates the right
connection of the Booster into the docking station.

2.5. DC docking station - Vehicle

Developed to be connected to the recovery vehicle's battery terminals, the simple fact
of putting the Booster back into its docking station allows it to be charged at 100% for
the next intervention.
Assembly:
Connect the cable lug of the blue cable to the negative terminal of the battery (or
n
the earth).
Connect the cable lug of the brown cable to the positive terminal of the battery.
n
A green LED is assembled at the top of your docking station and indicates the recharge
of the Booster.
If you have connected your docking station to an auxiliary power supply in your ve-
hicle, it will be necessary to switch on the ignition or to run the engine to supply the
station (green LED).
A one-way diode installed on the docking station avoids the discharging of the Booster
towards the vehicle.
For a well charged Booster, the tension of the place where you connect the docking
station must be around 14,4V, engine running at about 2000 rpm.
EN
41