EGO AURA-R2 RMR1500E Mode D'emploi page 28

EN
Error code
7001
7002
7003
8001
8002
8003
Symptoms
If the product does not operate correctly, refer to the symptoms below. Contact EGO service center if you still cannot find the reason for the error.
Problem
The product has difficulty docking.
The product slips when docking.
The product runs at the wrong time.
The product vibrates.
28
ROBOTIC MOWER — RMR1500E/RMR3000E/RMR6000E
Description
Mower location unavailable
Mower location unavailable
Local RTK station disconnected for
extended period of time
Camera overheated
Camera communication error
Camera dirty
Cause
1. The charging station is on a slope or not on
a level surface.
2. The charging station is not firmly installed.
Wet grass and mud stuck to the rear wheel
lead to the product to slip.
1. The starting and stopping times for mowing
are incorrect.
2. The product clock needs to be set.
1. Damaged blades lead to imbalance in the
cutting system.
2. Too many blades in the same position lead
to imbalance in the cutting system.
3. Missing blade in mounting position lead to
imbalance in the cutting system.
Solution
1. Restart the mower and put it on the charging station.
If the error persists, contact EGO support for remote assistance.
1. Restart the mower and put it on the charging station.
If the error persists, contact EGO support for remote assistance.
Local RTK station has been disconnected for an extended period of time.
1. Verify the status light on the bottom of the local RTK antenna.
◾
RED - RTK station abnormal
◾
GREEN - RTK station normal
2. Power off the local RTK station and power on it again.
If the error persists, contact EGO support for remote assistance.
The camera has been temporarily turned off due to high temperature.
It will restart automatically once the temperature returns to normal. No
action is required.
If the error persists, contact your EGO service provider.
Camera communication returns an error.
1. Power off and restart the mower.
If the error persists, contact your EGO service provider.
Camera lens may be dirty. Please clean it for better performance.
Solution
1. Place the charging station on a level
surface.
2. Check if the six screws fixed on the station
are loose.
Clean the wheels.
1. Reset the start time and stop time settings
for mowing.
Tap (Device Details) >Work Settings>Work
Schedule
2. Set the clock.
Tap (Device Details) >Others>Time Zone and
Country
1. Inspect the blades and screws and replace
them if necessary.
2. Check that only one blade is fitted at each
screw.
3. Check that the three blades are installed in
each mounting position.