EGO AURA-R2 RMR1500E Mode D'emploi page 24

EN
Error code
1016
2001
2002
2003
2004
3001
3002
3003
3004
3005
3006
4008
24
ROBOTIC MOWER — RMR1500E/RMR3000E/RMR6000E
Description
Driving motor calibration error
Battery fault
Charging stop due to the temperature
Low battery charge
Mowing stop due to the temperature
Angle sensor calibration error
RTK receiver fault
Electric self-test failed
Screen error
Lift sensor failure
Collision sensor failure
Charging station pairing unsuccessful
Solution
Driving motor calibration error
1. No actions required; the mower performs dynamic calibration
automatically during on the charging station.
If the error persists, contact your EGO service provider.
Battery has fault.
1. Power off the mower and contact your EGO service provider.
Charging stop due to over-temperature
1. No actions required; the mower will resume charging once the
temperature returns to normal.
If the error persists, contact your EGO service provider.
Battery capacity is too low.
1. Put the mower on the charging station to charge.
If the error persists, contact your EGO service provider.
Mowing stop due to the over-temperature.
1. No actions required; allow the mower staying on the charging station
until the temperature returns to normal.
If the error persists, contact your EGO service provider.
The angle sensor calibration returns an error.
1. Keep the mower level and stationary, then restart it.
If the error persists, contact your EGO service provider.
RTK receiver returns an error.
1. Keep the mower level and stationary, then restart it.
If the error persists, contact your EGO service provider.
Electric self-test returns an error.
1. Keep the mower level and stationary, then restart it.
If the error persists, contact your EGO service provider.
Screen communication failure.
1. Check whether the display is normal. If the screen shows
abnormalities, restart the mower.
If the error persists, contact your EGO service provider.
Contact your EGO service provider
Contact your EGO service provider
The mower failed in pairing with the charging station.
1. Please unplug and plug the charging station power cord, then press
the Start + OK button on the mower or tap Clear Error on the app, and
place the mower into the charging station.
2. If the error persists, restart the mower and try step 1 again.
If the error persists, contact your EGO service provider.