EGO AURA-R2 RMR1500E Mode D'emploi page 26

EN
Error code
6005
6006
6007
6008
6009
6010
26
ROBOTIC MOWER — RMR1500E/RMR3000E/RMR6000E
Description
Out of mapped boundary
Mower tipped over
Collision sensor stuck
Mower lifted
Mower tilted
Mower failed to return to charging
station
Solution
The mower has moved 1 m beyond the boundary of the working area.
1. Check if the boundary slope exceeds the slope limit (8.5°). If it does,
adjust the boundary.
2. Place the mower within the boundary. Then press the Start + OK
button on the mower to clear the fault code.
If the error persists, contact EGO support for remote assistance.
The mower is tipped over.
1. If the ground is uneven, level the lawn.
2. Check if the boundary slope exceeds the slope limit (8.5°). If it does,
adjust the boundary.
3. Check if the working slope exceeds the slope limit (26.6°). If it does,
set the area as a no-go zone.
4. Press the Start + OK button on the mower.
5. If the mower repeatedly gets dumping in the same spot, create a no-go
zone for the area where it fails to escape.
If the error persists, contact EGO support for remote assistance.
The mower collision sensor is stuck.
1. If there are obstacles near the mower, remove them; if the mower is in
a confined space, move it to an open area.
2. Press the Start + OK button on the mower to resume operation.
3. If collisions repeatedly occur in the same location, we recommend
creating a no-go zone for the area where the mower failed to escape.
If the error persists, contact EGO support for remote assistance.
The mower is lifted.
1. Place the mower on a flat surface and check if the caster bracket can
move vertically.
2. Then press the Start + OK button on the mower to clear the fault code.
If the error persists, contact EGO support for remote assistance.
The mower is tilted.
1. If the ground has bumps, level the lawn; Check if the boundary slope
exceeds the slope limit (8.5°). If it does, adjust the boundary.
2. Then press the Start + OK button on the mower to clear the fault code.
If the error persists, contact EGO support for remote assistance.
The mower can't return to the charging station.
1. Ensure there are no obstacles near the charging station and that it is
installed on a level surface.
2. Press the Start + OK button on the mower, or tap Clear Error in the
app.
3. Press Park + OK to return, or tap HOME in the app.
If the error persists, contact EGO support for remote assistance.