EGO AURA-R2 RMR1500E Mode D'emploi page 23

Error code Description
1007 Mowing motor overheat
1008 Cutting-height motor blocked
1009 Cutting-height motor overload
1010 Driving motor calibration error
1011 Left or right driving motor fault
1012 Left or right driving motor fault
1013 Left or right driving motor blocked
1014 Left or right driving motor overload
Left or right driving motor supply
1015
voltage too low
Solution
Mowing motor is too hot.
1. Allow the motor to cool.
NOTE: High power usage can excessively stress parts and lead to
reduced service life.
If this error persists, contact your EGO service provider.
Cutting height motor has stalled.
1. Power off the mower and check the mowing disk for damage and
obstructions.
2. Power on the mower and attempt to raise/lower the cutting height.
If this error persists, contact your EGO service provider.
Cutting height motor is overloaded.
1. Power off the mower and check the mowing disk for damage and
obstructions.
2. Power on the mower and attempt to raise/lower the cutting height.
If this error persists, contact your EGO service provider.
Driving motor calibration error.
1. Power off the mower and restart.
If the error persists, contact EGO support for remote assistance.
Problem with the power delivery to left or right drive motor.
1. Power off the mower and restart.
If this error persists, contact your EGO service provider.
Driving motor power supply is abnormal.
1. Power off the mower and restart.
If the error persists, contact your EGO service provider .
Left or right driving motor has stalled.
1. Check whether the wheels are jammed and remove obstructions.
2. Press the Start + OK buttons on the mower, or select Clear Error in
the app.
If the error persists, contact your EGO service provider.
Left or right driving motor is overloaded.
1. Check whether the wheels are jammed and remove obstructions.
2. Press the Start + OK buttons on the mower, or select Clear Error in
the app.
If the error persists, contact your EGO service provider.
Left or right driving motor power supply is abnormal.
1. Power off the mower and restart.
If the error persists, contact your EGO service provider.
ROBOTIC MOWER — RMR1500E/RMR3000E/RMR6000E
EN
23